FSIN

Sine

Opcodes

Hex Mnemonic Encoding Long Mode Legacy Mode Description
D9 FE FSIN None Valid Valid Replace ST(0) with its sine.

Description

Computes the sine of the source operand in register ST(0) and stores the result in ST(0). The source operand must be given in radians and must be within the range - 263 to +263. The following table shows the results obtained when taking the sine of various classes of numbers, assuming that underflow does not occur.

FSIN Results
SRC (ST(0)) DEST (ST(0))
- ∞ *
- F - 1 to + 1
- 0 -0
+ 0 + 0
+ F - 1 to +1
+ ∞ *
NaN NaN

If the source operand is outside the acceptable range, the C2 flag in the FPU status word is set, and the value in register ST(0) remains unchanged. The instruction does not raise an exception when the source operand is out of range. It is up to the program to check the C2 flag for out-of-range conditions. Source values outside the range -263 to +263 can be reduced to the range of the instruction by subtracting an appropriate integer multiple of 2π or by using the FPREM instruction with a divisor of 2π. See the section titled "Pi" in Chapter 8 of theIntel®64 and IA-32 ArchitecturesSoftware Developer's Manual, Volume 1, for a discussion of the proper value to use for π in performing such reductions.

This instruction's operation is the same in non-64-bit modes and 64-bit mode.

Pseudo Code

IF ST(0) < 263
	C2 = 0;
	ST(0) = sin(ST(0));
ELSE
	(* Source operand out of range *)
	C2 = 1;
FI;

FPU Flags Affected

C1: Set to 0 if stack underflow occurred. Set if result was rounded up; cleared otherwise. C2 Set to 1 if outside range (-263 < source operand <+263); otherwise, set to 0. C0, C3 Undefined.

Exceptions

Floating-Point Exceptions

Exception Description
#P Value cannot be represented exactly in destination format.
#D Source operand is a denormal value.
#IA Source operand is an SNaN value, ∞, or unsupported format.
#IS Stack underflow occurred.

64-Bit Mode Exceptions

Same exceptions as in protected mode.

Compatibility Mode Exceptions

Same exceptions as in protected mode.

Virtual-8086 Mode Exceptions

Same exceptions as in protected mode.

Real-Address Mode Exceptions

Same exceptions as in protected mode.

Protected Mode Exceptions

Exception Description
#UD If the LOCK prefix is used.
#MF If there is a pending x87 FPU exception.
#NM CR0.EM[bit 2] or CR0.TS[bit 3] = 1.